Vinyl project planning

Vinyl siding cost calculator

See a visible vinyl siding planning range before you decide whether to request written local pricing.

Your planning range

$6,832–$18,425

Expected project range for vinyl siding on a 1500 sq ft home. The labor calculation uses the selected story and complexity adjustment and the national state baseline until a ZIP is entered.

$3,465 materials$5,503 labor$2,250 removal

This is a planning estimate, not a quote. Wall area, trim, repairs, permits, and local scope can change a final price.

Want exact pricing? Get 3 free quotes

Built from the published rate card

The approved vinyl siding baseline is $4–$9 per square foot installed before the separately selected removal adjustment. The calculator does not turn that planning baseline into a contractor quote.

How this estimate is calculated

The calculator multiplies the selected home size by the approved material baseline, then applies the rate card’s labor-only adjustment for story height, project complexity, and an approved state multiplier when the ZIP maps to one. Materials remain on the national baseline; the location adjustment is not applied to them.

Removal is kept separate. When selected, the calculator adds the approved non-hazardous old-siding removal-and-disposal range of $1–$3 per square foot once. That prevents the common mistake of charging removal inside the installed baseline and then adding it again.

Inputs that should match the home

Exterior area starting pointHome square footage helps you begin, but contractors should measure siding wall area, openings, gables, waste, and attached structures before setting final quantities.

Stories and complexityStory height and the simple, standard, or complex selection affect the labor component because access, cuts, transitions, and safety time can change installation effort.

ZIP and state labor adjustmentA covered ZIP applies only the approved labor adjustment. If no approved state value applies, the calculator uses the default multiplier rather than inventing a local rate.

Removal selectionChoose removal only when existing siding must be taken off. The result does not assess hazardous materials, substrate condition, or hidden damage.

What to confirm in the written scope

Use the result to start a contractor conversation, not to skip one. Ask each installer to specify the siding product and finish, removal and disposal, wall preparation, wrap and flashing, trim, repairs, permits, change-order process, cleanup, and workmanship or manufacturer warranty terms. Compare the scope as carefully as the total price.

Vinyl products, wall area, stories, trim, removal, and access can change the final installation scope.

After the planning range

Request local pricing with your project inputs.

The calculator’s material, ZIP, size, story, complexity, and removal selections travel to the quote request so you do not have to enter the basics twice.

Step 1 of 9

Where is the project?

How does this vinyl siding calculator work?

It applies the approved low, expected, and high material baseline to the entered home size. The labor component then uses the selected story and complexity adjustment plus the approved state labor multiplier when a covered ZIP is entered.

Is the calculator result a contractor quote?

No. It is a planning estimate. A written contractor quote should confirm exterior wall area, product selection, removal, wall preparation, flashing, trim, repairs, permits, access, cleanup, and warranty terms.

Is existing siding removal included in this calculator?

Removal is a separate toggle. The approved installation baseline is removal-exclusive, so selecting removal adds the non-hazardous removal-and-disposal adjustment once rather than hiding it in every estimate.

Free, no-obligation help

Ready to compare a property-specific siding scope?

Tell us a few project details and compare local siding pricing. It takes about 60 seconds.

Get 3 free quotes